Skip to content

Image Armor DTG Pretreatment Cleaning Solution


Recommended for performing routine maintenance on the Viper XPT-6000 and the ViperONE, Image Armor Cleaning Solution breaks down active polymer solids and will cleanse all inner systems: pumps, solenoid valves, fittings, tubes, and spray nozzles. The cleaning solution also cleans all internal and external surfaces that have pretreatment residue.

Image Armor Features

  • Non-Flammable
  • Safe for Viper XPT Interior Components
  • Biodegradable
  • Environmentally Friendly
  • Low VOC, Zero GWP
  • Non-Ozone Depleting, Halide-Free
  • Prevents Ionic Contamination
  • pH in neutral range (6-9 pH)
  • Non-Corrosive

Directions for Cleaning the Viper XPT-6000

The Image Armor Cleaning Solution is designed to recirculate through your Viper XPT-6000 though the H2O Fluid IN and OUT ports. It is recommended that you use a separate container to hold recirculation fluid.

  • Empty the Viper of pretreatment by running a Fluid Empty routine
  • Place the water IN and OUT fluid lines into the container of Image Armor Cleaning Solution.
  • Run a Fluid FILL routine.
  • To fully clean and maintain the Viper, run 3-5 cycles of the fluid FILL routine.
  • Empty the Image Armor Cleaning Solution by running a Fluid Empty routine.
  • Place the water IN line back into a clean container of distilled water.
  • Place the water OUT line back into your waste water container.
  • Run two Fluid FILL routines using distilled water to remove the residue of the Image Armor Cleaning Solution from lines, pump and spray heads.
  • Empty the water from the Viper using the Fluid EMPTY routine on the Viper.
  • You are ready to re-introduce pretreatment into the Viper and start pretreating.